cooling - Five year old unopened boxed CPU – is the stock thermal compound still good?

08
2014-07
  • misha256

    I have obtained an unopened, sealed, boxed CPU dating back to 2009. It’s an Intel Core 2 Duo E8600 with heatsink + thermal compound pre-applied. Is the stock thermal compound still OK to use after five years on the shelf?

    • Answers
  • LPChip

    It should be, given that in the same amount of time, it could've been attached to a CPU and has to enure that as well.

    If you don't trust it, just scrape it off and apply fresh coolingpaste (which is different than those strips. The paste can actually dry out.

    Journeyman Geek points out that if its slightly hard it should be ok, if it crumbles like dried toothpaste, you need a fresh coat of the stuff.


    • Related Question

    heatsink - What's the proper way to remove thermal paste from a CPU?
  • Marcos Lara

    I'm replacing the heatsink on my CPU, and want to clear the current thermal paste.

    What should I do?


    • Related Answers
  • Áxel Costas Pena

    Use rubbing alchohol. It cuts the grease and dries quickly/safely for electronics.

    The preferred way to remove typical silicone oil-based thermal grease from a component or heat sink is by using isopropyl alcohol (rubbing alcohol). If none is available, pure acetone is also a valid method of removal.

    From Wikipedia

    Also the suggestion to use a credit card/business card to scrape off the paste first is a good idea.

  • kbyrd

    I have always scraped it off with a credit card, then used alcohol applied with paper towels and a q-tip to clean the residue.

    Wikipedia has more detail though:

    Computer processor heatsinks utilize a variety of designs to promote better thermal transfer between components. Some thermal greases have a durability up to at least 8 years. Flat and smooth surfaces may use a small line method to apply material, and exposed heat-pipe surfaces will be best prepared with multiple lines.

    Excess grease separating the metal surfaces more than the minimum necessary to exclude air gaps will only degrade conductivity, increasing the risk of overheating. Silver-based thermal grease can also be either slightly electrically conductive or capacitive; if some flows onto the circuits it can cause malfunctioning and damage.

    Over time, some thermal greases may dry out, have reduced heat transferring capabilities, or set like glue and make it difficult to remove the heat sink. If too much force is applied the processor may be damaged. Heating the grease by turning the processor on for a short period often softens the adhesion. Another method to use can be by turning the heatsink slowly instead of lifting it up. It is recommended that thermal grease be re-applied with each removal of the heatsink.

    Silicone oil-based thermal grease can be removed from a component or heatsink with an alcohol (such as rubbing alcohol) or acetone. Special-purpose cleaners are made for removing heatsink grease and cleaning the surfaces.