windows 7 - LCD TV as VGA Monitor does not go widescreen

07
2014-07
  • user22902

    My PCs graphics card is a VIA UniChrome Pro III. The TV is a Digistar 27 inch LCD and supports a 1280 x 800 resolution.

    Under Screen Resolution in Windows 7, I can choose 1280x800 and 1280x768, but both result in the TV going to 1024 x 768. However if I set the resolution to 1280x1024 the TV gets set to this.

    What could be wrong? Why does it refuse HD resolutions?

    • Answers
  • techie007

    Are you SURE the TV supports that resolution? I googled it a bit and the max resolution seems to be advertised as 1366 x 768 (aka 720p), with 1080i and p downscaled to 720p.

    If 1366x768 is not an available option when you go to select the wanted resolution, then you may want to figure out what VIA chipset is on your motherboard (as the S3 Unichrome Pro video is part of the VIA chipset) and then go get the latest drivers from VIA or your motherboard manufacturer, as it may/will add those extra resolutions (if the UniChrome supports them at all).


    • Related Question

    display - Why would I get an electric shock from a VGA cable connected to an LCD monitor?
  • CoffeeBean

    While arranging cables tonight to prepare to plant a new workstation, I got an electric shock from the VGA cable (that was hooked up to a seemingly good, yet older LCD monitor).

    Of course, when the monitor was powered off, it didn't happen, but when we plugged it back in, I got the same jolt, and decided to trade monitors before electrifying a brand new workstation.

    Does anyone know exactly what goes wrong inside an LCD monitor to cause this? I know older CRTs were shock-worthy, but I never expected it from newer technology.


    • Related Answers
  • CarlF

    There's an electrical fault in the monitor. I hope it's under warranty.

    It is NOT the signal for the picture, which is extremely low voltage and high frequency and cannot be felt. It's probably a short in the monitor which has put real voltage on a cable meant only to carry a signal. Unplug it, leave it unplugged, and either get it fixed or dispose of it.

    Nothing to do with "new technology" here--the problem isn't in the technology, it's a wire making contact with the wrong part.

  • Don Salva

    but I never expected it from newer technology.

    Why not?

    Somehow the signals needs to be transferred from a to b, in order to do that they need energy of some sort. Electricity is the way to go..

    Wherever Electricity comes into play, there always is a chance to get shocked, however mild or severe.

    In order not to be shocked, Electricity need to run into the earth, thus the technical term "to ground". If you get shocked it's mostly due to faulty grounding.

    Faulty grounding results in YOU being the medium it (the electricity) needs to run into the ground (a complete circuit), thus shocking you.

  • Ganesh R.

    The shock is due to electrical signals (from the monitor) flowing through your body. The signal is always present(when monitor is on), just that it needs the circuit to be completed. Normally when you connect it to a workstation, the circuit is completed by the workstation. But when you hold it, its you who complete the circuit & hence the shock :).